crobertson
09-26-2008, 05:00 PM
Connecting to a Mohawk Server *Rough Draft*
1. Start Mohawk: Once you've started Mohawk you'll be greeted with the programs main interface. (Picture (http://mohawkvoice.com/faq/connecting-to-server/1.png))
2. Make a new connection: Select the "Setup" button near the top right and a new window with several options will appear. First you're going to fill out the the following: Server Address/Port, Username. (Picture (http://mohawkvoice.com/faq/connecting-to-server/2.png))
3. Set audio settings: Usually the defaults will be fine, but if you have several devices plugged into your computer you can select which one will act as the speakers, microphone, or both (headset, speakers + mic, etc). (Picture (http://mohawkvoice.com/faq/connecting-to-server/3.png))
4. Connect!
1. Start Mohawk: Once you've started Mohawk you'll be greeted with the programs main interface. (Picture (http://mohawkvoice.com/faq/connecting-to-server/1.png))
2. Make a new connection: Select the "Setup" button near the top right and a new window with several options will appear. First you're going to fill out the the following: Server Address/Port, Username. (Picture (http://mohawkvoice.com/faq/connecting-to-server/2.png))
3. Set audio settings: Usually the defaults will be fine, but if you have several devices plugged into your computer you can select which one will act as the speakers, microphone, or both (headset, speakers + mic, etc). (Picture (http://mohawkvoice.com/faq/connecting-to-server/3.png))
4. Connect!